|
I already disconnected everything from the PSU by the time I read your post, tw. I was unable to get any readings at all from the female connectors of the PSU. I think the prongs of my multimeter are a little too fat to fit inside them. I did do the hot wiring thing from the 3rd pin to the 4th pin. That's supposed to run the fan. I plugged the PSU in, and the fan ran for about 5 seconds and then stopped. I tried unplugging and replugging several times, but the fan doesn't run.
Your idea to leave everything connected and take measurements while the system is running all the peripherals won't work here because it won't start up.
I"m going back in, and I'm going to see if I can figure out a way to get a measurement from those pins.
|