a photoblog of what i did today.....

[glatt]

We bought a used car a couple weeks ago, and knew when we got it that the brakes were pretty worn and would need to be replaced soon. So at around 2PM Saturday, I realized I had a beautiful 4.5 hour empty window until we were meeting friends for dinner. I stopped in the auto parts store and bought new brake pads.

I got home and switched the cars in the driveway and my son and I proceeded to take the front wheel off the driver's side. I went to install the new pads, but they didn't fit! So back to the store to exchange them. This time with an old pad in hand to make sure I had the right ones before I left. I got a knowledgeable clerk this time and everyone was extremely apologetic that they gave me the wrong part initially.

Now I was feeling a little pressure, somehow I had only 2 hours now, and still needed to take a shower. I did the driver's side brakes with no problem, and figured the passenger's side would be even faster. Except I couldn't get two of the five lug nuts off. I sprayed them several times with WD40 and then got cleaned up and went to dinner with the friends.

So Sunday morning, I went out there and tried again. The lug nuts wouldn't budge. So I heated them with a propane torch, and they still wouldn't budge. Finally, I decided to use more muscle than I thought I should. And I snapped them both clean off! I would have been pissed if I was on the side of the road, but this was a controlled environment and I was happy to get the wheel off.

So my photoblog begins with this picture.

See the three nice wheel stud bolts and the two broken ones? This will not do. Let's fix it.

First we remove the brake caliper piston assembly thing and hang it by a bent coat hanger from one of the giant springs holding up the car. We're hanging it because the line full of brake fluid is too weak to hold up this big and heavy hunk of metal and I don't want to have to mess with replacing brake fluid and bleeding air out of the system, so I just leave the whole thing attached to the brake fluid lines. But I want it out of the way, so I hang it up.


Next comes the pads. They are old and worn, so I pull them out of the brake mount assembly. I want to save them for now because I'll need to reuse the shims in a bit.



The old pads next to the new ones.